HPE Community
Operating System - HP-UX
1835960 Members
3247 Online
110088 Solutions
New Discussion

Re: AUTO file on vpars

 
anidil
Occasional Advisor

‎03-03-2011 02:21 PM

‎03-03-2011 02:21 PM

AUTO file on vpars

Hi

I know that we have to set AUTO file to "boot vpmon -a" to boot all the vpars automatically. What I am not clear is whether we have to set it on all the vpars or just the initial vpar?

From below monitor command output, I am assuming my initial vpar is using cell 2. is that correct ?

MON> bootpath
Legacy : 2/0/0/2/0.6.0
Lunpath: 2/0/0/2/0.6.0

Thanks
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎03-04-2011 12:55 AM - last edited on ‎08-04-2011 11:17 AM by

‎03-04-2011 12:55 AM - last edited on ‎08-04-2011 11:17 AM by

Re: AUTO file on vpars

Better set it on all possible boot disks, just in case you boot the system rom these disks.

See also

http://h30499.www3.hp.com/t5/LVM-and-VxVM/Root-Mirroring-in-Vpar-s/m-p/5275622#M49177


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.