HPE Community
Operating System - HP-UX
1833758 Members
2589 Online
110063 Solutions
New Discussion

B2600, raid unit and tape drive

 
Tgunawan
Occasional Advisor

‎08-31-2004 09:53 PM

‎08-31-2004 09:53 PM

B2600, raid unit and tape drive

I have a B2600 connected to Raid unit in Raid 1 mode, before I install a tape drive it was run perfectly. After install a tape drive, I got the following error:
LVM: VG0 : PV0 (device x 1f030000) is POWER FAILED. and system hanged there. But if tape drive was remove system was OK again.
Do any body came acrros this problem before?

Regards,
Ted
0 Kudos
Reply
3 REPLIES 3
Sunil Sharma_1
Honored Contributor

‎08-31-2004 10:03 PM

‎08-31-2004 10:03 PM

Re: B2600, raid unit and tape drive

check for SCSI ID of tape drive. It may be saem as one of the disk.

sunil
*** Dream as if you'll live forever. Live as if you'll die today ***
0 Kudos
Reply
Sunil Sharma_1
Honored Contributor

‎08-31-2004 10:08 PM

‎08-31-2004 10:08 PM

Re: B2600, raid unit and tape drive

Your disk (device x 1f030000)has SCSI ID 0 so make sure tape's SCSI should not clash with any disk's scsi ID.

Sunil
*** Dream as if you'll live forever. Live as if you'll die today ***
0 Kudos
Reply
Tgunawan
Occasional Advisor

‎09-01-2004 08:20 PM

‎09-01-2004 08:20 PM

Re: B2600, raid unit and tape drive

hi all,

the problem are due to termination setting on raid unit should be set to disable and /home directory can not be more than 9 gb.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.