HPE Community
Operating System - HP-UX
1847998 Members
7896 Online
104022 Solutions
New Discussion

BIND 9.2.1 on HP-UX 11.i

 
Malcolm Galindo
Occasional Contributor

‎07-24-2002 03:11 PM

‎07-24-2002 03:11 PM

BIND 9.2.1 on HP-UX 11.i

Has the issue with "incompatible SIOCGLIFCONF ioctl" with HP-UX 11.i been resolved. I am needing to install BIND 9.2.1 on an 11.i machine. If so, was there a patch that was released to correct the problem? Thanks in advance!

Malcolm
0 Kudos
Reply
2 REPLIES 2
kish_1
Valued Contributor

‎07-24-2002 07:35 PM

‎07-24-2002 07:35 PM

Re: BIND 9.2.1 on HP-UX 11.i

I think try send query to following address, you will get some info,
bind9-bugs@isc.org.
share the power of the knowledge
0 Kudos
Reply
rick jones
Honored Contributor

‎07-25-2002 09:25 AM

‎07-25-2002 09:25 AM

Re: BIND 9.2.1 on HP-UX 11.i

You can always compile the bits on 11.0 and run the binary on 11i. I've done that before with the BIND 9 stuff.

The SIOCGLIFCONF stuff was resolved in the 8.something line about a month or three ago. I suppose that it would be appearing in whatever the next BIND 9 release is going to be. If that is too far out, you could grab the BIND 8 bits and see what was changed and make those changes to the bind9 bits.
there is no rest for the wicked yet the virtuous have no pillows
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.