buffer memory paramters and glance o/p

[DeafFrog]

Dear Gurus,

filecache_max and filecache_min on ia63 v3, rx6600 is kept at auto.
With DB running on the server , memory utilization from glance shows 79%.
I understabd this is due to buffer thru above 2 paramters and that
glance memory utilization may not be corect picture.

however, during a load test , the memory utilization in glance was 100%.
vmstat showed po (vhand active, upto 132 po).My question :
filecache paramter should be kpt as auto , but will setting it up manually
to 30 % (filecache_max) and 15 % (filecache_min) be of help.(or any suggested value).

regards.

[Michal Kapalka (mikap) · Accepted solution]

hi,

did you read this docu ??

http://h21007.www2.hp.com/portal/download/files/unprot/devresource/Docs/TechPapers/UXPerfCookBook.pdf

mikap

[DeafFrog]

thanks Michal.