Cannot see CPU on npar

[Janet Sanberg]

I have an rp7420 which is npar'd 2 ways. On each cell there are 4 dual core CPU's - but when I do a parstatus I can only see 3:

[Cell]
CPU Memory Use
OK/ (GB) Core On
Hardware Actual Deconf/ OK/ Cell Next Par
Location Usage Max Deconf Connected To Capable Boot Num
========== ============ ======= ========= =================== ======= ==== ===
cab0,cell0 active core 6/0/8 16.0/ 0.0 cab0,bay0,chassis0 yes yes 1
cab0,cell1 active core 6/0/8 16.0/ 0.0 cab0,bay0,chassis1 yes yes 0

How do I get it to recognize the last CPU (so it will read 8/0/8). The CPU is physically there (I've looked directly at the cell).

Also at the CM, then I do a PS, I see:

CPU Module Slot 0 1 2 3
Populated P P P
Local 48V Good * * *
Power Enabled * * *
Power Good * * *

But again, the 4th dual core is physically there. Both npars have this issue so I do not think it is bad hardware, must be configuration?

[S.N.S]

Hi Janet,

Any specific issues - like abrupt shutdown/power failure - before this happened?

What does the MP > SEL logs Show - any 'Alerts'?

HTH out,
SNS

[Torsten.]

What is the result of this?

# icapstatus

[Janet Sanberg]

No everything is clean and green. I have another machine that is configured like this on both npars as well, which is why I think it is configuration and not hardware issue.

[Janet Sanberg]

# icapstatus
sh: icapstatus: not found.
# which icapstatus
no icapstatus in /usr/bin /usr/sbin /sbin .

[Deeos]

hi,

can you share with me

#parstatus -V




Regards
Deeos

[Janet Sanberg]

Deeos -thank you for your replay. This has been resolved, I will close the thread. thanks!!

[Janet Sanberg]

Thank you for your replies.

[Torsten.]

" This has been resolved,..."

We all would like to know how this was solved ...

;-)