cant see lancard

[Jannik]

I have a lancard in a server i can't see!
I can only see the build in BTLAN:
# ioscan -funC lan
Class I H/W Path Driver S/W State H/W Type Description
===================================================================
lan 0 0/0/0/0 btlan3 CLAIMED INTERFACE HP PCI 10/100Base-TX Core
/dev/diag/lan0 /dev/ether0

The server is a N-Class installed with 11.00. I would think i need to install something.
The server has been booted!

[Hoefnix]

If its an other lancard then the btlan3 you would probable need to install it's driver.
If you can figure out the harware address of it's slot that the lancard is installed in you can try to query on that using ioscan:

ioscan -fncH 1/12/0.... (fill in you own hardware address)

Regards,

Peter

[Sunil Sharma_1]

Hi,

How many LAN Cards you have in server ?

you have to configure driver for LAN card in kernel.

anyway one lan port whihc is on core i/o is already configured you can use it.

Sunil

[Dietmar Konermann · Accepted solution]

If you leave away -C lan from your ioscan command then you should at least see _something_... what type of interface is it?

I would guess you need to install:

J4253AA B.11.00.05 100BT/9000 PCI

It's on the application CDs (DART).

Best regards...
Dietmar.

[Jannik]

the card is a B5509-66001 10/100BT I think at least it looks like one.

[Jannik]

Is it:
J4253AA B.11.00.05 100BT/9000 PCI

I need to install for:
B5509-66001 100Base-TX LAN host adapter board with one RJ-45 port - Requires one PCI slot - Includes the board, software, software license, and installation instructions - For HP-UX operating system

[Sunil Sharma_1]

hi,

Have a look on this page. similer problem

http://aa11.cjb.net/hpux_admin/2000/08/0232.html

you may require B5509BA s/w

Sunil

[Sunil Sharma_1]

Hi,

I think this s/w is available in Application CD.

Sunil

[Dietmar Konermann]

Hmm... looks like the B5509BA is supposed to be installed in workstations only. However, it also uses the btlan5 driver, which is in the J4253AA bundle also.

Best regards...
Dietmar.

[Jim Butler]

Change the pci slot that you plugged into.

Boot the system

Install all the appropriate software listed above

run the command insf -e

verify that the driver is in /etc/system

If not, add it and rebuild the kernel
mk_kernel
kmupdate

reboot

Good Luck