HPE Community
Operating System - HP-UX
1834625 Members
3288 Online
110069 Solutions
New Discussion

Chanching IP-adress

 
BR642688
Occasional Contributor

‎05-01-2002 11:42 PM

‎05-01-2002 11:42 PM

Chanching IP-adress

What is the procedure to follow to change a IP-adress of a HP9000 D330 HP UX 10.2 server.

Why do it difficult when it can be done easy
0 Kudos
Reply
2 REPLIES 2
BR627460
Frequent Advisor

‎05-02-2002 02:59 AM

‎05-02-2002 02:59 AM

Re: Chanching IP-adress

Probably the easiest way is to use sam

enter sam
- Networking and communications
- Network Interface Cards
Select your lan card
-Actions
-Modify

you can then change ip address


If you just want to use the command line then enter-

#set_parms ip_address

Cheers

George

An expert is a person with extensive knowledge or ability based on research, experience, or occupation and in a particular area of study. Think if you match that description before you tick those damn boxes!
0 Kudos
Reply
BR19682
Esteemed Contributor

‎05-02-2002 03:58 AM

‎05-02-2002 03:58 AM

Re: Chanching IP-adress

Hi there.
The described procedure is ok, but be sure, that you really want it.
You take the risk, that parts of your installed software will not run anymore.
Reason is, that the licence string for sample is hooked to the ip-address ( OmniBack since version 3 ).
Check this first, before you take any action.
Rgds
Alexander M. Ermes
.. and all these memories are going to vanish like tears in the rain! final words from Rutger Hauer in "Blade Runner"
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.