HPE Community
Operating System - HP-UX
1833875 Members
3300 Online
110063 Solutions
New Discussion

Re: cluster re-config when removing network interface

 
Matthias Oswald
Advisor

‎04-27-2007 01:12 AM

‎04-27-2007 01:12 AM

cluster re-config when removing network interface

I would assume that I do not need to halt the cluster when removing a broken interface card from the cluster configuration ?

Thanks,
Matthias
mabios
0 Kudos
Reply
1 REPLY 1
Steven E. Protter
Exalted Contributor

‎04-27-2007 01:29 AM

‎04-27-2007 01:29 AM

Re: cluster re-config when removing network interface

Shalom,

No, cmhaltnode should be sufficient to take a node out of the cluster and fail all its packages to other nodes.

Any packages that do not fail over shows deficiencies in cluster design and testing.

Since the new NIC card will probably be detected as the same lan# as the old, reconfiguration will probably be not needed after the work.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.