cmcld: Either there is no configuration data or cmclconf

[Weiqiang Wu_1]

Hi,

Need help in cmcld.
While the L2000 HP-UX 11.0 server is rebooted without shutdown the cluster, it failed to start the cmcld. Please refer to the syslog.

Please advise.

Thanks,
Wei

*********************

Aug 4 03:08:22 srv1 CM-CMD[1420]: /usr/sbin/cmrunnode -v
Aug 4 03:11:02 srv1 cmclconfd[1592]: Request from node srv1 to start the
cluster on this node.
Aug 4 03:11:02 srv1 cmclconfd[1592]: Executing "/usr/lbin/cmcld" for node srv1.r01.com
Aug 4 03:12:02 srv1 cmcld: Either there is no configuration data or cmclconf
d is unable to run.
Aug 4 03:19:02 srv1 cmclconfd[1592]: The ServiceGuard daemon, /usr/lbin/cmcl
d[1629], exited with a status of 1.

[Devender Khatana]

Hi,

Post the contents of /var/adm/cmcluster.
What is the patch level & service guard version ?


HTH,
Devender

[Rajesh SB]

Hi,

Can you give some more details like,
what is the node state in the output of cmd #cmviewcl

what is output showing upon runing cmd
# cmviewconf

Regards.
Rajesh

[Kent Ostby]

Wei --

Keep in mind that when you boot a ServiceGuard node, it can only JOIN a cluster or a form a cluster if the other node(s) in the cluster are booting at a similar time.

The startup runs "cmrunnode" as oppossed to "cmruncl".

If what you did above was done without the cluster up and running then it is normal behaviour.


If the cluster was up and running, then you are probably looking at an issue with nslookup not finding the names correctly or something of that nature.


Best regards,

Oz