Command failed with exit value = 200

[rbarlow]

Hi All,

I'm completely new to HP-UX and HP Virtual Machines and just installed HPVM on a new server to do some testing. Here's what I have installed:

# swlist | grep -i 'integrity vm'
T2767CC B.04.20 Integrity VM
T8718AC B.04.20 Integrity VM Online Migration Sof
tware
VMGuestLib B.04.20 Integrity VM Guest Support Librar
ies
VMGuestSW B.04.20 Integrity VM Guest Support Softwa
re
VMKernelSW B.04.20 Integrity VM Kernel Software
VMMGR A.4.1.0.78229 HP Integrity VM Manager

Here is the problem I'm running into. When I execute commands at the command prompt (like hpvmcreate, hpvmremove, hpvmnet, etc), everything works fine. When I access the Integrity Virtual Machines Manager within SMH, I can see everything that I have done in the command line, however whenever I try to perform any alterations (create virtual machine/switch, start/stop virtual switch, etc), I receive the following error message:

Command failed with exit value = 200

I performed a "# hpvmstatus -e" and there are no errors recorded.

I thought it was a WBEM credential issue but I recorded the root account and password in it.

Has anybody run into this before or have any suggestions for further troubleshooting? If you require more information then please send the exact commands to enter because like I mentioned I'm still very new with HP-UX.

Thanks!