HPE Community
Operating System - HP-UX
1829101 Members
2736 Online
109986 Solutions
New Discussion

command to delete RAID 0 through saconfig

 
SOLVED
Go to solution
Torsten.
Acclaimed Contributor

‎04-05-2011 07:27 AM

‎04-05-2011 07:27 AM

Re: command to delete RAID 0 through saconfig

OK.


As said, I would create a bigger RAID set, but smaller logical drives (depends on what you need).

You don't need to make the complete disk a logical drive.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.