Operating System - HP-UX
1830898 Members
3223 Online
110017 Solutions
New Discussion

command view sdm questions

 
SOLVED
Go to solution
Gustavo Venturini deLim
Occasional Advisor

command view sdm questions

Hi, I've the same errors in the thread 871735 (http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=871735 but I've changed the IP address...
Reinstall doesn't work...
Anyone can tell me what's happening?
Thank's.
4 REPLIES 4
RAC_1
Honored Contributor
Solution

Re: command view sdm questions

I could not open that link. Post the error message. When you changed the ip address, did you follow the correct procedure??

It is always good to do /etc/set_parms ip_address
Check that.

Anil
There is no substitute to HARDWORK
erics_1
Honored Contributor

Re: command view sdm questions

There's a closing ')' in the link above which causes the link to fail.

Does the hostname command return the actual hostname?

Does this match the output of uname -a?

Run nslookup
nslookup
-->Do both of these match?

Regards,
Eric
Gustavo Venturini deLim
Occasional Advisor

Re: command view sdm questions

Hi, I've removed the /opt/sanmgr and the /etc/opt/sanmgr, reinstall the SDM and add my IP on the /etc/opt/sanmgr/hostagent/config/access.dat.
That's solve the problem.
Thank's for help.
Gustavo Venturini deLim
Occasional Advisor

Re: command view sdm questions

Hi, I've removed the /opt/sanmgr and the /etc/opt/sanmgr, reinstall the SDM and add my IP on the /etc/opt/sanmgr/hostagent/config/access.dat.
That's solve the problem.
Thank's for help.