Configuration lan Autonegotiation = on

[Eli Daniel]

Hi, these are other server

SAPL918_RX6600:/> nwmgr -A all -c lan0
lan0 current values:
Link State = Up
Speed = 100 Mbps Half Duplex (Autonegotiation : On)
MTU = 1500
MAC Address = 0x001a4b0985e0
Receive Flow Control = On
Transmit Checksum Offload = Off
Receive Checksum Offload = Off
Virtual MTU = 0
TCP Segmentation Offload is now disabled.
Max Send Buffers = 1
Max Send Coalesce Ticks = 150
Max Recv Buffers = 1
Max Recv Coalesce Ticks = 0
Interrupt Throttle Mode = -1
Diagnostics Threshold = 0
512byte transmit buffer size limit = 0

how modify Half Duplex and full Duplex???

[Zinky]

The RX6600 is "different" as it has Physical HBAs. Your BL870c utilizes likely a "share" of your Blade Enclosure's (a C7000?) virtual Connect infrastructure -- which is set by the Blade Management software.

I see your RX6600 is only set at half duplex (with auo-neg on) -- if your Network infrastructure is indeed Gigabit capable -- then there is likely a problem with your switch's port settings -- have your network admin set the switch port for your RX6600 to auto, no-neg as well and your RX6600 should communicate at 1000 Full auto.

[Eli Daniel]

Thanks, the configuration lan is OK. the problem is IP and swich.