Operating System - HP-UX
1830100 Members
11022 Online
109998 Solutions
New Discussion

Configure ignite version 6.8.152 to use ssh istead of using rexec

 
SOLVED
Go to solution
Juan Gonzalez_2
Frequent Advisor

Configure ignite version 6.8.152 to use ssh istead of using rexec

I am running Ignite C.6.8.152 on HPUX 11.23. Question I have is can I configure this version of ignite to use ssh instead of rexec to connect to the client servers. Since at this company rexec is disabled both on the server and the firewall. If I can not use ssh in the version of ignite to connect the clients what version of ignite can I use and how do you setup it up to use ssh?

Thanks in advance for any information you can provide.
3 REPLIES 3
OFC_EDM
Respected Contributor
Solution

Re: Configure ignite version 6.8.152 to use ssh istead of using rexec

This may be a starting point for you:

http://docs.hp.com/en/5992-3346/5992-3346.pdf?jumpid=reg_R1002_USEN
On page 153 it states the following option for ignite

-S Directs ignite to use ssh based protocols instead of remsh based protocols
when communicating with remote systems for initiating recovery sessions
or client reboots.

The Devil is in the detail.
OFC_EDM
Respected Contributor

Re: Configure ignite version 6.8.152 to use ssh istead of using rexec

Check page 23 too it has a section called "Using SSH with bootsys"
The Devil is in the detail.
OFC_EDM
Respected Contributor

Re: Configure ignite version 6.8.152 to use ssh istead of using rexec

Hi Juan,

Did you get it working?

Maybe you can post your solution when you close the thread?

Don't assign me any points for this post.

Cheers
The Devil is in the detail.