HPE Community
Operating System - HP-UX
1826419 Members
4062 Online
109692 Solutions
New Discussion

Configuring Lan0 & Lan1 on L2000 (rp5450)

 
Christina Martin
Frequent Advisor

‎02-21-2008 01:53 PM

‎02-21-2008 01:53 PM

Configuring Lan0 & Lan1 on L2000 (rp5450)

We are trying to configure lan1 to work on a rp5450 in addition to lan0 which is already configured and working. When we configure lan1 and reboot, we end up loosing all connection to the server via either lan card. Is there something specific we need to be doing? How do we enable both lan cards to run at the same time?
0 Kudos
Reply
2 REPLIES 2
Patrick Wallek
Honored Contributor

‎02-21-2008 01:57 PM

‎02-21-2008 01:57 PM

Re: Configuring Lan0 & Lan1 on L2000 (rp5450)

How exactly are you configuring them? What IP addresses are you using? If each card has an IP address in the same subnet (for example lan0=1.2.3.4 and lan1=1.2.3.5) then that is unsupported and will not work.

The 2 lan cards must have IP addresses in different subnets.
0 Kudos
Reply
Michael Steele_2
Honored Contributor

‎02-21-2008 02:21 PM

‎02-21-2008 02:21 PM

Re: Configuring Lan0 & Lan1 on L2000 (rp5450)

Hi Christina:

Need to see all configuration on both and commands or just netconf file.
Support Fatherhood - Stop Family Law
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.