Console Message????

[mark.M]

i has rx5670 server.
when i'm find dumy console message on server.
what is it?


**********100Mb/s PCI LAN/9000 Networking

Thu Jan 26 kst 2006 09:20:31 632416 DISASTER Subsys=PCI100BT

Loc:00000 <6001> HPPCI100 10/100BASE-T driver detected bad cable connection between

the adapter in slot land the hub or switch

[Kasper Hedensted]

Hi Mark,

Last time I saw this error, it was due to a bad cable.

Cheers,
Kasper

[Peter Godron]

Mark,
please check your network cable.
Probably worth swapping it.

[Torsten.]

The physical connection between the network card and the switch is lost (bad/removed cable?). Please check this.

[Chauhan Amit]

This message can come due to following reasons:

a) Bad Cable
b) Port fault on Hub/Switch
c) Faulty Hub/Switch

You can pin point the fault by checking other systems connected to the same Hub/Switch. If all systems are getting above message,most probably Switch issue. Switch reboot may also cause this message.

Regards,
Amit Chauhan

[Darrel Louis]

Mark

Do you've STM installed on your server?
Check with STM if you can get more info, also if STM is installed you should see messages in your syslog.log file.

Does dmesg give you any messages?

Darrel

[Muthukumar_5]

Refer this:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=717809

--
Muthu

[Devender Khatana · Accepted solution]

Hi,

It could be due to

1. Bad cable
2. Bad port
3. Link up/down for some time.

Is the problem repeating or came only once?

HTH,
Devender

[Peter Godron]

Mark,
have you got an update on this?
If the problem is fixed, please identify the solution, award points and close.