HPE Community
Operating System - HP-UX
1840188 Members
3924 Online
110162 Solutions
New Discussion

Re: Disk Subsystem Queue

 
Jason Tan
Advisor

‎01-29-2003 11:02 PM

‎01-29-2003 11:02 PM

Disk Subsystem Queue

If disk subsystem queue is high (say 10), where should we look at in glance or perfview to isolate root cause of the problem?
smtan
0 Kudos
Reply
1 REPLY 1
Ian Dennison_1
Honored Contributor

‎01-30-2003 01:17 AM

‎01-30-2003 01:17 AM

Re: Disk Subsystem Queue

Jason,

If the value of 10 is consistently shown, then there may be a problem. Are you experiencing performance delays? If the response is still good, then this may just be the way that the Application operates.

Are you striping or alternate-pathing?

Has the Application been tuned properly first, to make best use of the resources it has? Table buffering in memory, etc?

Share and Enjoy! Ian
Building a dumber user
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.