HPE Community
Operating System - HP-UX
1832069 Members
2843 Online
110034 Solutions
New Discussion

DTC Manager and Router Cisco

 
Mario Cervantes
Frequent Advisor

‎10-22-2004 10:52 AM

‎10-22-2004 10:52 AM

DTC Manager and Router Cisco

I need to configure DTC Manager in my HP-9000 but I need to reach my DTCs throught a Cisco router. I guess I am not reaching my DTCs from my HP-9000 because my router blocks my comunications ports.

Does anybody know the ports that use DTC Manager to reach each DTC?

Regards.
Mario Cervantes.
0 Kudos
Reply
2 REPLIES 2
Joseph T. Wyckoff
Honored Contributor

‎10-22-2004 12:05 PM

‎10-22-2004 12:05 PM

Re: DTC Manager and Router Cisco

Moving to a more closely related forum (I hope) - this has nothing to do with Omniback / Data Protector, as far as I know...
Omniback and NT problems? double check name resolution, DNS/HOSTS...
0 Kudos
Reply
melvyn burnard
Honored Contributor

‎10-22-2004 09:47 PM

‎10-22-2004 09:47 PM

Re: DTC Manager and Router Cisco

Well if they are out via a routed network, then you need to use DTC-RX manager, and the correct DTC models for this.
If I remember correctly the standard DTC Manager would not allow management of DTC's via a routed network.
My house is the bank's, my money the wife's, But my opinions belong to me, not HP!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.