Entria Plus configuration

[Blake Irvine]

I'm trying to configure an Entria Plus to use the UPT/10BaseT port, and it doesn't seem to link. The terminal appears to want to connect via Thinnet. The "cable not connected" icon appears when I try to use a UTP cable. We don't have thinnet here anymore...

Blake Irvine
Systems Specialist
Cal Poly State University
birvine@calpoly.edu
(805) 756-6549

[GMPUNIX]

Don't know if you are still around since this message is quite old, but did you ever find a solution to the no link issue on the UTP port? Thanks,
Bob

[Blake Irvine]

I actually found the solution to this problem, although I am no longer using the Entria Plus devices.

The devices apparently only support 10Mb connection speeds. We had to configure the switch to force the port to be 10Mb. Also forced half- or full-duplex, can't remember which. I'd suggest trying 10Mb half-duplex.