Envizex X-Terminal

[Marcos Nunes]

I have 12 envizex p serie installed in my workplace.
Unfortunately I forgot the setup password of one of these terminals.
I woul??d appreciate to know how to bypass or reset the setup password.
Regards
Marcos

[Domenico_5]

hi marcos

try with "secret" if I remember it's a backdoor

regards

Dom.

[Domenico_5]

or try with

after it boots around the time you here the 2 beeps .... keep your fingers pressed
down.

It's reset the factory defaul

good luck


dom

[Bill McNAMARA_1]

nope, it's letmein

Although you can find out what it is by

Security Flaw follows, not worth fixing, if you ask:

remsh xterm cat /dev/nonvol | strings
or was that
remsh xterm strings /dev/nonvol

can't remember, don't have my xt, maybe alex can test.

Later,
Bill "knows the innards of these things" McNAMARA

[Alex Glennie]

Hi Bill,

Your wish is my command ;)

tried both your suggestions on /dev/ffs1/nonvol ..... no joy : letmein didn't work either but maybe that was Irish humour. .... ?

Secret has worked for me in the past but not with the latest xterminal models - Envizex II's and Entria II's

remsh get novol works ... password is shown up something like :

0x00630000 x.7.1.6

mine was the second from last entry in the list of outputs .....

[Brian McEntire]

Hello,
Thanks all for the advice in this thread! I was not the original poster, but I recently received an HP Envizex pSerise X Terminal and there was a password set (preventing me from reconfiguring it.)

Pressing immediately after I heard the 2 beeps at boot time did the trick.

Thanks! (These HP Forums are great! Google failed me this time, but HP came through :)