FAIL in HP-UX Start-up?

[Mousa55]

Hi All,

i am upgrade my system from 11.11 to 11.23, it is successfully finished the 2 OS MC-OE CD.
but after the system rebooting automatically and when arrive to " HP-UX Start-up in progress"
some FAIL start up and more is N/A it is appeared

Start Kernel Logging facility FAIL *
Set privilege group N/A
Display date N/A
Start CIM cimserver subsystem FAIL *
Initialize Instant Capacity FAIL *
Starting ISEE hpservices mad daemon. N/A
Start Runner N/A
Starting X Font Server at TCP port 7000 N/A
Start vt daemon N/A
Start time synchronization N/A
Start accounting ..... N/A
Install/Load XF86 DLKM Helper Modules N/A

how to solve this problem?

Note: i am not use the Application CD and support pack CD.

thanks and bestregards

[sujit kumar singh]

hi

Start the diagnosis starting from having a look at the /var/adm/syslog/syslog.log and /etc/rc.log


Regards
Sujit

[likid0]

You can also try to launch the services manually once the server has booted.

Then check the output you get on syslog and the console, and see if you get any info on the errors.

Start CIM cimserver subsystem FAIL *
/sbin/init.d/cim_server stop|start
Initialize Instant Capacity FAIL *
/sbin/init.d/icod stop | start

[Mousa55]

Hi All,

and this error message it is appeared after finish the start-up HP-UX progress

An error has occurred !



Check for possible errors.
id:icod "/usr/lbin/icodd # iCOD daemon"

INIT: Command is respawning too rapidly.
Will try again in 5 minutes.
Check for possible errors.
id:icod "/usr/lbin/icodd # iCOD daemon"

and i am try to run the services manually but the problem is still
# /sbin//init.d/cim_server start
PGS10021: CIM server error: PGS00613: One or more tags are still open on line 22.
ERROR CODE 1

# /sbin/init.d/icod start
ERROR: The following low-level error occurred:

Cannot connect to local CIM server. Connection failed.
ERROR: /etc/inittab is missing the required entry for
the Instant Capacity daemon (icapd).
Refer to the icapd (1m) man page for more
information.
ERROR: The following low-level error occurred:

Cannot connect to local CIM server. Connection failed.
ERROR: The Instant Capacity (iCAP) Agent
was unable to reconcile the number of active
processors with the intended number of active
processors. For further information about
the Instant Capacity status, run icapstatus (1m).


how to solve it?

thanks

[likid0]

For the icap problem, you need to have this line in the inittab:

[root@rxprinte:cmcluster/iprocess]# cat /etc/inittab | grep -i icap
icap:23456:respawn:/usr/lbin/icapd # Instant Capacity daemon


If you don't have it edit the inittab,add it, and do a #init q

[Steven E. Protter]

Shalom,

Your upgrade-ux process has failed as it often does.

Your system is probably not usable. You will need to either restore the backup you made before you started or do a cold install of 11.23 followed by new application software install.

SEP