Fail to reboot

[John Fung]

Would any one can help me to resolve the rebooting problem, after restoring from an ignite tape. Actually, it was successfully reboot in the first time. After I change the ip address and the host name.

Then I receive LCD front panel message FLT CBF1,FLT CBFC, FLT CBF0 and BUS 5002. They all continue and loop showing in the panel screen. It is a D250 machine.

[Sanjay_6]

Hi John,

Take a look at the thread below, This link refers to the K-Class troubleshooting guide. The error codes for k-class are there at the bottom. Maybe they will help you isolate the problem on your D-class too,

http://us-support.external.hp.com/cki/bin/doc.pl/sid=2abe97c116c2a8e82e/screen=ckiDisplayDocument?docId=500000000083759

Hope this helps.

Regds

[harry d brown jr]

You said you were restoring from an ignite tape, did it come from another D250 with the same configuration?

live free or die
harry

[Michael Tully]

Hi,

Restoring an ignite tape should work, but you may run into troubles if it was cut from a different server.
Generally speaking you should be able to recover from any ignite tape as long as it was cut on on equal type of server. 'D' class and 'K' class should be okay together.

You should always have a created ignite tape as a backup for each and every server where possible.

-Michael

[Printaporn_1]

FLT most potentialy be hardware problem.
I would suggest you log Hardware case to HP Solution Center.
They need to decode FLT code.

[Santosh Nair_1]

Those LCD codes indicate a HPMC, which generally point to a hardware problem. I don't this it has anything to do with your ignite image (especially since you say you were able to boot up once). Call HP and have them replace the faulty part(s).

-Santosh

[Yohanes]

Hi all,

Could you help me also ?? I have same problem in K250 after replacing System Board. But i don't have Ignite tape to restore. My Server can't boot and suspect PDC Firmware fault, so need to Replace System Board. After i Replace the system board A3284-60010, when booting i receive LCD Fron panel message FLT CBF1, CBFC, CBF0, BUS 5008, BUS 5408, BUS 5508, FLT A088. They all coninue and loop showing in the panel screen.

How to recover this ?? may i do wrong steps to replace ??
Thanks.

[Tim Krego_2]

I have a CBF0 FLT TRAPS error on my K460 LCD. I tried to swap the system board with no success.

I was getting a FLT 3000 originally, which happens earlier in the boot cycle.

My problem is that we don't have HP support on this box. So I have to go it alone.