HPE Community
Operating System - HP-UX
1755701 Members
4738 Online
108837 Solutions
New Discussion юеВ

Following message in syslog

 
SOLVED
Go to solution
HSW Support
Advisor

тАО03-23-2001 01:33 AM

тАО03-23-2001 01:33 AM

Following message in syslog

Morning all,

I have the following message in syslog :

LVM: PV 0 has been returned to vg[0]

I also received an EMS notification of a SCSI hardware failure but all tests seem ok. See the attached file for the event notification.

Any ideas what this means,

Mike
0 Kudos
Reply
2 REPLIES 2
Printaporn_1
Esteemed Contributor

тАО03-23-2001 02:04 AM

тАО03-23-2001 02:04 AM

Solution

Re: Following message in syslog

Hi,

This can cause bu scsi timeout ,
please check do you have latested scsi and LVM patch.
enjoy any little thing in my life
Reply
Steve Lincz
New Member

тАО04-03-2001 07:53 AM

тАО04-03-2001 07:53 AM

Re: Following message in syslog

This can also be caused by a busy system / scsi bus. Make sure you've applied the latest scsi patches.

If on an external array or enclosure, you can run " pvchange -t 180 /dev/dsk/c#t#d# to increase the timeouts. The default is 30 seconds.
No question is dumb if you don't know the answer.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.