Getting quick started with Ignite

[Meir Dukhan]

I need to install an Ignite server mostly for system recovery of an HPUX farm (approx 80 10.20 & 11.0, most of them 11.0).

I'm looking for a quick way to get started.

I'm already familiar with make_tape_recovery but would like to switch to Ignite server to avoid the tape administrativa and have better recovery capabilities.

I'm especially fascinated by the possibility to recover a whole system disk via network.

Thanks in advance,

-- Meir

[aparna challagulla · Accepted solution]

hi Meir,

go thro the software recovery handbook wherein u will find a chapter on ignite-ux.i think this is a good resource for u to get started.
http://www1.itrc.hp.com/service/iv/node.do?node=prod%2FWW_Start%2FN1%7C16%7C19

HTH
aparna

[T G Manikandan]

check this doc

http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000066258954

you can have more information here

http://software.hp.com/products/IUX/infolib.html