HBA config

[terry123]

hi All,

may i know can i change the setting of a HBA card? how can i change the link speed? the Topology?

by running "fcmsutil /dev/fclp0", comes out with the following result

# fcmsutil /dev/fclp0

Vendor ID is = 0x10df
Device ID is = 0xfe00
PCI Sub-system Vendor ID is = 0x103c
PCI Sub-system ID is = 0x7046
Chip version = 2
Firmware Version = 2.70X5 SLI-3 (Z3D2.70X5)
EFI Version = ZE3.21A3
Driver-Firmware Dump Available = NO
Driver-Firmware Dump Timestamp = N/A
Topology = PRIVATE_LOOP
Link Speed = 4Gb
Local N_Port_id is = 0x000001
Previous N_Port_id is = 0x000001
Local Loop_id is = 125
N_Port Node World Wide Name = 0x50060b0000fd7063
N_Port Port World Wide Name = 0x50060b0000fd7062
Switch Port World Wide Name = 0x0000000000000000
Switch Node World Wide Name = 0x0000000000000000
Driver state = ONLINE
Hardware Path is = 0/2/0/0/0/0
Maximum Frame Size = 2048
Driver Version = @(#) FCLP: PCIe Fibre Channel driver (FibrChanl-02), B.11.23.0712, Oct 5 2007, IFC (3,1)

thx.

b.r.
terrytse

[smatador]

Hi,
I don't think so. fcmsutil is a diagnostic tool. If you want to manage or tune look at scsimgr
Some docs
http://docs.hp.com/en/netsys.html#Storage%20Area%20Management

[Duncan Edmonstone · Accepted solution]

You don't set these parameters - the FC card will detect what the other end is set to, and set itself appropriately. You card seems to be set to private loop - suggesting its direct connected to some device.

If this isn't waht you want, you'll have to look at changing the other end as the HPUX FC card will just auto-sense what the other end wants and configure itself based on that.

HTH

Duncan

[terry123]

thx all for the help