HPE Community
Operating System - HP-UX
1833760 Members
2188 Online
110063 Solutions
New Discussion

How can send atachments using elm by command line?

 
Armando Carreto
Occasional Contributor

‎09-18-2001 06:53 AM

‎09-18-2001 06:53 AM

How can send atachments using elm by command line?

Im Trying send attachments using elm program, in version 11.0 works only using interactive mode but I need use command line.
0 Kudos
Reply
2 REPLIES 2
Bill McNAMARA_1
Honored Contributor

‎09-18-2001 07:07 AM

‎09-18-2001 07:07 AM

Re: How can send atachments using elm by command line?

If you look right down at the bottom of this page you'll see one of the top 5 read solutions is:

http://forums.itrc.hp.com/cm/QuestionAnswer/1,1150,0x41950559ff7cd4118fef0090279cd0f9,00.html

I don't believe it! ;)

Later,
Bill
It works for me (tm)
0 Kudos
Reply
Bill McNAMARA_1
Honored Contributor

‎09-18-2001 07:11 AM

‎09-18-2001 07:11 AM

Re: How can send atachments using elm by command line?


just to clarify, 'this page' is the hp-ux family home, http://forums.itrc.hp.com/cm/FamilyHome/1,1148,117,00.html

not the networking home which has a different top 5!

Good luck,
Bill
It works for me (tm)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.