How to solve this problem?HP-Unix rp8400

[David_492]

Dear All

I made a partion on HP-UNIX Server rp8400 to two nodes node1 and node2 and every node has it's own ethernet port and ip address , the ip address's are on the same network and they have the same subnet.

The problem that i can ping node1 but i can not ping node2 i check the lan of node2 i found it disabled i enabled again inorder to ping node2 this time i pinged but i can not ping node1?

Thank You all

[Ravi_8]

Hi,

#ioscan -fnC lan

you need to assign lan card i/o addresses to the partitions while craeting, which by default detect the respective lan card while booting

[Jeff Schussele]

Hi David,

I suspect that there's a problem with the Vlan settings on the switch that these are connected to.
Also are these partitions "hard" Npars or "soft" Vpars?

Rgds,
Jeff

[Alzhy]

Hi David,

You will have to be more specific about this problem. Do you have 2 nPars (which is the maximum hard partition on the rp8400) or one nPar config'ed to two vPars?.
.