hp-ux 10.2 installation problem

[Yilak Yehualashet]

When i try to re-install 10.2 on HP Workstation Visualize B180L. After searching boot devices, it identifies both CD-rom and disk drives.

But when it starts booting from CD-ROM, It gives the following messages

Warning: No dump device configured. Dump is disabled.

And after that it starts scanning I/O devices and it says "no disk devices found"

help

[Vincenzo Restuccia]

SCSI termination is ok?

[Yilak Yehualashet]

SCSI Termination is ok

[Pedro Sousa]

Hi Yilak!
Maybe you are installing a non supported version of 10.20.
Check in the manual if there is any specification about that. Maybe HPUX 10.20 ACE.
good luck.

[Pedro Sousa]

---------------------------------------------------------------------
| | HP-UX 10.20 | HP-UX 11 |
| |-------------|------------|-----------|
| | 32-bit | 32-bit | 64-bit |
|----------------------------|-------------|------------|-----------|
| | J6000 | ACE 9912 | N/A | ACE 9911 |
| |-----------|-------------|------------|-----------|
| PA-8600 | J5600 | ACE 9912 | N/A | ACE 9911 |
| |-----------|-------------|------------|-----------|
| | C3600 | ACE 9912 | N/A | ACE 9911 |
|----------------|-----------|-------------|------------|-----------|
| | J7000 | ACE 9912 | N/A | ACE 9911 |
| |-----------|-------------|------------|-----------|
| PA-8500 | C3000 | ACE 9912 | N/A | ACE 9911 |
| |-----------|-------------|------------|-----------|
| | B2000 | ACE 9912 | N/A | ACE 9911 |
|----------------|-----------|-------------|------------|-----------|
| PA-7300LC | B180L | ACE 9912 | ACE 9911 | N/A |
---------------------------------------------------------------------

[Pedro Sousa]

sorry for the last output!
That is a table where you can see if you're installing the right HPUX 10.20 version:
B180L - HPUX 10.20 ACE 9912
My last thought

[Vincenzo Restuccia]

In PDC prompt you can see all boot devices ?
(sea is the command)

[Yilak Yehualashet]

using sea command all boot devices are listed

[Joseph C. Denman]

Hummmm....

I agree with the above responses; it sure sounds like you are using a wrong version of the core os. Check doc to ensure you are using the correct/supported version.

...jcd...

[Vincenzo Restuccia]

Core OS is for sries 700?

[Leehaksung]

Hi, friend,

I have same problem on my C200 workstation to installing HP-UX 10.20.
what do you do for this problem?

Mark,