HP UX 11.0 Kernel parameters via SAM

[Roboz]

Hi folks, I wonder if you have seen the following problem:
OS=HPUX11.0
LATEST Patched installed: PHNE_30989,PHKL_32920,PHNE_31096
PROBLEM: When tried to list the kernel parameters using sam, it failed with the following messages.

Internal error: Cannot find driver/module "" in the internal kernel configuration data structures

Looking at the sam log, it lists out the following error messages.

ERROR SAM couldn't complete an entire recalculation of parameter values. One parameter SAM was unable to recompute was "st_san_safe" with a planned value of "". (error code "0").

ERROR Failed to find a matching driver for the name/class "".

I have look about but can not find a clear answer to this problem. The system is currently running. The problem may have been introduced earlier but is only now that I need to adjust the kernel parameters.

I'll appreciate you assistance. Thanks.

[RAC_1]

what does sysdef/kmtune -l say??
Do you get same errors??

[Adisuria Wangsadinata_1]

Hi,

You need to install this patch below to solve the problem :

PHCO_31879 : s700_800 11.00 cumulative SAM/ObAM patch

This is the link for the patch :

http://www1.itrc.hp.com/service/patch/patchDetail.do?BC=patch.breadcrumb.main|patch.breadcrumb.search|&patchid=PHCO_31879&context=hpux:800:11:00

Check also the thread below :

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=150018

Hope this information can help you.

Cheers,
AW

[Roboz]

THANK YOU SO MUCH FOLKS... you comments were most useful.

[Arunvijai_4]

Assign points if you find posts are useful. ;-)

-Arun

[Roboz]

Hi folks... thank you for your help. I did assign point to everyone.. ;)