HPE Community
Operating System - HP-UX
1829816 Members
1716 Online
109993 Solutions
New Discussion

HPUX_Support_libmtra

 
Court Campbell
Honored Contributor

‎06-08-2007 02:26 AM

‎06-08-2007 02:26 AM

HPUX_Support_libmtra

OS: 11.11

Here is the error I get when running mk_kernel:

Generating module: krm...
Generating module: rng...
cc: "what_vers.c", line 35: error 1714: Identifier "HPUX_Support_libmtra" is initialized more than once.
*** Error exit code 1 (ignored)
ar: could not open what_vers.o
*** Error exit code 1 (ignored)
Compiling conf.c...
Loading the kernel...
Generating kernel symbol table...

I remove the duplicate HPUX_Support_libmtra line in what_vers.c. I also removed the duplicate libmtra.a line in config.SAM.mk and config.mk. the config.mk recreates the what_vers.c but even though I edit it it still adds the duplicate line. I am not sure what file I need to edit to clear this error. The kernel compiles OK, it's just a annoyance. Any ideas?
"The difference between me and you? I will read the man page." and "Respect the hat." and "You could just do a search on ITRC, you don't need to start a thread on a topic that's been answered 100 times already." Oh, and "What. no points???"
0 Kudos
Reply
2 REPLIES 2
Dennis Handly
Acclaimed Contributor

‎06-08-2007 01:36 PM

‎06-08-2007 01:36 PM

Re: HPUX_Support_libmtra

You should contact the Response Center.
0 Kudos
Reply
Court Campbell
Honored Contributor

‎06-08-2007 02:26 PM

‎06-08-2007 02:26 PM

Re: HPUX_Support_libmtra

Where's the fun in that???
"The difference between me and you? I will read the man page." and "Respect the hat." and "You could just do a search on ITRC, you don't need to start a thread on a topic that's been answered 100 times already." Oh, and "What. no points???"
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.