HPE Community
Operating System - HP-UX
1833780 Members
2357 Online
110063 Solutions
New Discussion

HSX and LVM maintenance mode

 
andre de wet_2
Occasional Contributor

‎07-30-2007 08:21 PM

‎07-30-2007 08:21 PM

HSX and LVM maintenance mode

HOw can I get the HSX driver (Secure Path for EVA3000) activated in LVM maintenance mode to "fix" the hardware paths to the LVM disks, using vgscan?
0 Kudos
Reply
3 REPLIES 3
Torsten.
Acclaimed Contributor

‎07-30-2007 08:43 PM

‎07-30-2007 08:43 PM

Re: HSX and LVM maintenance mode

Do you need to boot from this path?

Otherwise it is not necessary to adjust this in maintenance mode.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
andre de wet_2
Occasional Contributor

‎07-31-2007 06:39 AM

‎07-31-2007 06:39 AM

Re: HSX and LVM maintenance mode

yes, the LUN in question is a boot mirror
0 Kudos
Reply
andre de wet_2
Occasional Contributor

‎07-31-2007 09:08 PM

‎07-31-2007 09:08 PM

Re: HSX and LVM maintenance mode

We are trying to do a Disaster Recovery on a different system by booting from the SAN / EVA boot mirror. Because of the hardware differences, the paths to the disks change and needs to be "fixed" in hpux -lm mode. The boot from the EVA boot disk works fine into maintenance mode, but when I try moveing /etc/lvmtab away and doing a vgscan, LVM does not find the correct disks for vg00. It looks like the HSX driver is dynamically loadable and thus not loaded in maintenance mode.

How can I activate or load this module?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.