HPE Community
Operating System - HP-UX
1827054 Members
4268 Online
109713 Solutions
New Discussion

i can't create default gateway

 
atef_3
Contributor

‎10-06-2007 02:23 AM

‎10-06-2007 02:23 AM

i can't create default gateway

HP 9000 ,HP-UX 10.20
when i create default gateway
via SAM or via command
"route add default 130.230.10.1 1"
the following message appear :
" The function fork failed . There is not enough available memory"
0 Kudos
Reply
3 REPLIES 3
Dennis Handly
Acclaimed Contributor

‎10-06-2007 08:02 AM

‎10-06-2007 08:02 AM

Re: i can't create default gateway

You need to increase the swapspace.
0 Kudos
Reply
skt_skt
Honored Contributor

‎10-06-2007 02:19 PM

‎10-06-2007 02:19 PM

Re: i can't create default gateway

looks like mem/swap is fully utilized
0 Kudos
Reply
Steven E. Protter
Exalted Contributor

‎10-06-2007 07:22 PM

‎10-06-2007 07:22 PM

Re: i can't create default gateway

Shalom,

Your system seems to be under memory pressure.

Prior to increasing swap, perform some analsysis (see your other thread).

swampinfo -tam

There is advice in your swap section on whether or not increasing swap is a good idea. You might be able to solve this problem merely by shutting down a memory hungry process.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.