HPE Community
Operating System - HP-UX
1829009 Members
2302 Online
109986 Solutions
New Discussion

Ignite/Boot error process

 
Tom Smit
Occasional Contributor

‎02-13-2002 11:15 AM

‎02-13-2002 11:15 AM

Ignite/Boot error process

I'm having a problem using an ignite installation on an A180 to ignite an A500. I have attached the errors that i am receiving, but, it appears to get through the swinstall of the process, but dies on the subsequent reboot. I receive the following errors (horked.txt) and then the machine reboots, going into a vicious cycle of error, reboot, error, reboot. Any help would be appriciated.
0 Kudos
Reply
1 REPLY 1
Patrick Wallek
Honored Contributor

‎02-13-2002 11:24 AM

‎02-13-2002 11:24 AM

Re: Ignite/Boot error process

I think you are going to be better off installing the OS from scratch on the A500.

You problem almost surely stems from the fact that the A180 supports ONLY the 32-bit version of HP-UX and the A500 supports ONLY the 64-bit version of HP-UX.

See here for the HP-UX 11.x 32/64 bit server support list:

http://devresource.hp.com/STK/serversupport.html

Therer is NO way to get around this other than to install the OS on the A500 from scratch.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.