Ignite error after fresh install

[Jim McKee_1]

I just installed HP-UX 11.23, from the December 2005 kit, on a test N-Class machine. When I try to do an Ignite backup, I get the following error:

* Checking Versions of Recovery Tools
* Creating System Configuration.
* /opt/ignite/bin/save_config -f /var/opt/ignite/recovery/client_mnt/0x0
0306E0C3CE7/recovery/2006-08-14,13:47/system_cfg vg00
save_config: Error - cannot determine lv "/dev/vg00/lvol2" usage via fstyp
ERROR: /opt/ignite/bin/save_config failed

lvol2 is the standard HFS swap volume.

Any ideas on what is causing this error and what the fix is?

[IT_2007]

check syslog and check swapinfo -nt. Also see lvlnboot -v vg00 to see if it is properly configured or not. If not run lvlnboot -R to fix it.

[Jim McKee_1]

Swapinfo and lvlnboot both look good.

# swapinfo -nt
Kb Kb Kb PCT START/ Kb
TYPE AVAIL USED FREE USED LIMIT RESERVE PRI NAME
dev 4194304 0 4194304 0% 0 - 1 /dev/vg00/lvol2
reserve - 184776 -184776
memory 6291456 1063556 5227900 17%
total 10485760 1248332 9237428 12% - 0 -
# lvlnboot -v vg00
Boot Definitions for Volume Group /dev/vg00:
Physical Volumes belonging in Root Volume Group:
/dev/dsk/c0t0d0 (0/0/1/0.0.0) -- Boot Disk
Boot: lvol1 on: /dev/dsk/c0t0d0
Root: lvol3 on: /dev/dsk/c0t0d0
Swap: lvol2 on: /dev/dsk/c0t0d0
Dump: lvol2 on: /dev/dsk/c0t0d0, 0

[Dave Hutton]

I think this was a known problem with a specific version of ignite with 11.23. I had the same issue and once I upgraded to the latest version it worked.

I'm 99% sure I found this answer from the forums here or some source google found.

[Dave Hutton]

I should of searched in another browser, no points on this one. But heres the thread I had found:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1035279