ignite error

[Balaji Naigu Gudi]

Hi,

When we are running ignite backup on production server, it's hangining after the below message.

** 0 - The Volume Group or Filesystem is Not included in the
System Recovery Archive
** 1 - The Volume Group or Filesystem is Partially included in the
System Recovery Archive
** 2 - The Volume Group or Filesystem is Fully included in the
System Recovery Archive

* Checking Versions of Ignite-UX filesets

could you please advise on this error.

[Ludovic Derlyn]

hi

Could you give more informations :

-ignite release
- What is the command launched for ignite backup

what informations are located in /var/opt/ignite/logs ?

regards

L-DERLYN

[Ralf Seefeldt]

Hello,

this doesn't sound like an Errormessage to me.

What is the load of the system, diskusage, ...?

Are there any messages in syslog?

what is the version of the gnite-UX filesets. May you uptate ignite?

Regards
Ralf

[DCE]

These are informational messages, not error messages.

What leads you to believe there is a problem?

Ignite does not start writing to tape, rather it inventories the lvols being backed up first, then writes to tape. You will see a delay (the length of which is dependent on the amount of data and the spped of the system) before the tape write begins

[Balaji Naigu Gudi]

hi,

ignite version:C.6.7.79
backup command:
make_tape_recovery -A -v -a /dev/rmt/0mn.

logs in:/var/opt/ignite/logs
# cd logs
# ll
total 0
----------------------------------
error in /var/opt/ignite/recovery/recovery.log

Creating System Configuration.
* /opt/ignite/bin/save_config -f
/var/opt/ignite/recovery/2007-07-25,17:53/system_cfg vg00
NOTE: run_cmd: Process: 6470 (/opt/ignite/bin/save_config): killed by
signal: 15.
ERROR: /opt/ignite/bin/save_config failed
.

above is the error. i killed the job and rerun it, its completed successfully. please asist why its happen.might be problem with ignite ux files. may be files mismatch,here iam attaching find it. can u pls advise on this.Thank You.

[skt_skt]

what u posted at first is not there in last post.. where did u see the informations in the first phase.

Looking at the second phase, it looks like you or some had a kill command when the save_config was going on.

"above is the error. i killed the job and rerun it, its completed successfully".. looks like your kill command is what casued the error. save-config will take time depending on what is there in the system.

as far i remember the make_tape_recovery creates one more log file than what u mentioned above..(it creates under `date` folder