HPE Community
Operating System - HP-UX
1838136 Members
3264 Online
110124 Solutions
New Discussion

ignite make_recovery single ended to fast/wide disk

 
Terry L. Harrington
New Member

‎11-20-2002 08:02 AM

‎11-20-2002 08:02 AM

ignite make_recovery single ended to fast/wide disk

I have made a make recovery tape on a 735 workstation where the boot disk was a single
ended disk. I am attempting replace the boot
disk with a fast/wide disk. The ignite boot tape will not recognize the fast/wide as an IO
device. The initial server search for IO devices shows that it is installed.
0 Kudos
Reply
3 REPLIES 3
harry d brown jr
Honored Contributor

‎11-20-2002 08:17 AM

‎11-20-2002 08:17 AM

Re: ignite make_recovery single ended to fast/wide disk

What version of ignite are you running? You might need the newer version.

live free or die
harry
Live Free or Die
0 Kudos
Reply
RAC_1
Honored Contributor

‎11-20-2002 08:36 AM

‎11-20-2002 08:36 AM

Re: ignite make_recovery single ended to fast/wide disk

I think the difference with disks should be a problem.

But use the latest Ignite.
There is no substitute to HARDWORK
0 Kudos
Reply
Terry L. Harrington
New Member

‎11-21-2002 10:03 AM

‎11-21-2002 10:03 AM

Re: ignite make_recovery single ended to fast/wide disk

The ignite version that I am using is A.2.3.205
I have been told that any version after 3 will
not work on a 735.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.