Operating System - HP-UX
1833540 Members
2769 Online
110061 Solutions
New Discussion

Ignite recovery issue !!!

 
Anand Sreenivasan
Regular Advisor

Ignite recovery issue !!!

Hopefully someone out there faced this issue and can help me.
I have a system with 2 internal disks and I am trying to push a image to this system from my ignite server.

Once I issue bo lan. install

It goes thro the hard booting message and after trying to relocate PDC pages, Comes out with this error,
************ SYSTEM ALERT **************
SYSTEM NAME: uninitialized
DATE: 06/25/2010 TIME: 20:28:13
ALERT LEVEL: 3 = System blocked waiting for operator input

REASON FOR ALERT
SOURCE: 1 = processor
SOURCE DETAIL: 1 = processor general SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail

LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH FLASH ON ON
LED State: Unexpected Reboot. Running non-OS code. Non-critical error detected.
Check Chassis and Console Logs for error messages.

0xF8E010301100EFFF 00000000 0000EFFF - type 31 = legacy PA HEX chassis-code
0x58E018301100EFFF 00006E05 19141C0D - type 11 = Timestamp 06/25/2010 20:28:13
A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:

and when I acknowledge it , IT just reboots . It does boot to the disk ok, Atleast I am able to get to login prompt. What am I dealing with here, Is this hardware issue or my image is all messed up. I have used same technique in other 4 boxes and they all worked fine. Any help is appreciated !!
4 REPLIES 4
AnthonySN
Respected Contributor

Re: Ignite recovery issue !!!

what is the Server model?
what is the model of the server which you have taken ignite backup of?
Anand Sreenivasan
Regular Advisor

Re: Ignite recovery issue !!!

The model of the server is 5470 and the model from where the image was taken is 5470 !! Thanks.
nightwich
Valued Contributor

Re: Ignite recovery issue !!!

Hi Anand


I don't have a ignite server, so no experience.

But it seems that your client can't find your image.

To test your image test the restore again in one of the working machines.

Then you know your problem is in the client side. Maybe hardware problem.

Check please.

Regards.
AnthonySN
Respected Contributor

Re: Ignite recovery issue !!!

did yiu try a fresh tape ignite restore.
i think the image is corrupted