Ignite restoration issue...

[boomer_2]

hi guys,
When m trying to restore ignite bkup m gettng the fllwn message :->


Message From: /opt/ignite/bin/itool () │ ││
│ │ │ │ ││
│ │ E│ NOTE: The disk at HW path: 0/1/1/0/4/0.0.0 does not exist on the │ ││
│ │ │ system and was specified in the configuration for the system. No │ ││
│ │ [│ substitute disk could be found, so it will be removed from the │ ││
│ │ │ configuration. │ ││
│ │ F│ │ ││
│ │ │ NOTE: The volume group vg00 will be removed from the configuration │ ││
│ │ [│ since there are no disks associated with it. │ ││
│ │ │ │ ││
│ │ [│─────────────────────────────────────────────────────────────





Server details ...rx4640
11i v2
8 gb ram

No error when took ignite bkup....

[Torsten.]

Is this backup taken from the same system?

The hardware path

0/1/1/0/4/0.0.0

is the core I/O scsi, but it is not an internal disk.

Did you connect an external disk to the bottom port of the core I/O by chance?

[boomer_2]

hi Torsten,
no external connecn was made....
this backup was taken frm d same system....

[Torsten.]

So I'm sure there was an upgrade made from the normal core I/O SCSI card to an smartarray SA640x card.

Can you confirm?

In this case, check the RAID config.

Press SHIFT 8 while the RAID card BIOS prompt you to go to the ORCA (config tool).

[Torsten.]

Same system?


http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1159646

[boomer_2]

hi torstesn,
i had my 1 mnth back ignite tape wid me....
i restored it from that tape..nw everythng is fine....thnks....

[boomer_2]

Hi Torsten,
Extremely sorry for the typo mistake.......

Yes m talking about the same system...but nw i have restored it from my previous ignite tape...
i think sme issue wid my ignite tape only....


Thanx again ..

[boomer_2]

REstored fom my old ignite tape