Ignite-UX configuration

[Joydeep_1]

Hi Gurus,

I want to configure IGNITE-UX server in one of the server. I already installed Ignite-UX software on that server. Now my question is generally we run make_recovery to make recovery tape. Now is it possible to keep all servers recovery image in IGNITE-UX servers under any directory. Like I don't to use to make any tape. It should keep in the server.

Another thing like I have server A in different location . I want to make make_recovery thru WAN & after that I want to use same tape to install HP-UX in one local server. I think I have to use make_net_reovery.

Please guide me how I can setup IGNITE-UX server as usual can make make_net_reocvery tape.

[Steve Steel]

Hi




It seems to me like you should look at some documentation.
The Web site http://www.software.hp.com/products/IUX
might be a good place to start. Especially the FAQ section.

Also note that when you install the product, there will be man pages for commands like make_tape_recovery, and the release documentation is very good.

The Administration guide for Ignite is available at http://docs.hp.com/hpux/onlinedocs/B2355-90704/B2355-90704.html


Steve Steel

[Sanjay_6 · Accepted solution]

Hi Sandip,

Take a look at the thread below.

This doc explain network archiving and recovery using ignite,

http://us-support3.external.hp.com/cki/bin/doc.pl/sid=9804b40f0eb27d1b7f/screen=ckiDisplayDocument?docId=200000043976541

Hope this helps.

Regds

[Sanjay_6]

Hi Sandip,

Here is the ignite ux admin guide,

http://www.software.hp.com/products/IUX/docs/sysadm.html

Hope this helps.

Regds