Installing Modem In HP UX

[Jason_216]

hi, can you guy tell me how to install a single modem in the hp ux server?

my server configuration are as below:
- two RP7410 HA custer server,
- a Aztech 56k serial modem.

just stage out the procedure of it, coz i am new in unix and lack of training for HP-UX.

thx

[Shaikh Imran]

hi,

Never done this.
but you can try from here :
http://www.compute-aid.com/hpmodem.html

OR
The following thread where the same discussions had taken place earlier:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?admit=716493758+1093842871689+28353475&threadId=58950

I will advise you to use sam for
better start & results.

Regards,

[G. Vrijhoeven]

Hi Jason,

You could check this link:

http://docs.hp.com/cgi-bin/fsearch/framedisplay?top=/hpux/onlinedocs/B2355-90698/B2355-90698_top.html&con=/hpux/onlinedocs/B2355-90698/00/00/24-con.html&toc=/hpux/onlinedocs/B2355-90698/00/00/24-toc.html&searchterms=modems&queryid=20020103-020152

HTH,

Gideon

[Jason_216]

k, i have installed alreadly, but how do i test it, is there any program or script to test or monitor it.


pls , thx

[Darren Prior]

Hi Jason,

It depends on what you are using it for as to how you should test it.

Firstly you should confirm that the device files are present and have the correct attributes. Next you should check that you have configured the modem's dip switches or internal settings correctly.

If you are using dial in access, then dial in to the modem and check that it answers and provides the correct prompts. Test this at least 2 times, to prove that the modem and port reset correctly.

For dial out usage either test using your application, or use Kermit or cu to dial out to a known working modem.

regards,

Darren.