1837893 Members
3546 Online
110122 Solutions
New Discussion

Re: IRM problem

 
SOLVED
Go to solution
Noel Daniel
Advisor

IRM problem

I have a real problem!

My RAID controller crashed! My disks are intact. I have the exact new RAID controller in stores. But I have no data backups of recent. Any way of configuring the new RAID controller, so that I could read my data which is the disks ? any help will be much appreciated, since I think I am in a fix !
2 REPLIES 2
Torsten.
Acclaimed Contributor
Solution

Re: IRM problem

RAID4si?

Disconnect the cables and note the connections. Make sure the new conztroller has no config (remove batteries).

Install the controllers and cables and boot.

Run IRM -> configure -> view/add config

select disk config (not nvram).

Check end exit the config tool (esc).

The controller saves the current config to nvram.

Check with irdisplay -f

If I find the manual I'll post the link.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Torsten.
Acclaimed Contributor

Re: IRM problem

Found it:

http://docs.hp.com/en/J6173-90007/ch05s02.html#cdgbdcha

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!