kernel ?

[navin]

i need to add kernel parameters using sam on a hp11.23 .
Please advice
thanks

[Steven E. Protter · Accepted solution]

Shalom,

Log in as root

sam

Kernel

Configurable parameters.

When done, sam will guide you through a kernel recompile and system boot.

This can all be done manually with kctune. If everything you change is dynamic then sam or kctune will not need to boot the system. The status, dynamic or statis is displayed in sam.

SEP

[navin]

Actually i do not see the below parameter in sam "maxswapchunks " and "semmap"

Please advice.
Thanks

[Sp4admin]

Hi Navin,

I'm not sure what kernel you are wanting to change. Just use SAM --> Kernel configuration --> Select Tunables then hit enter and then you will see the kernel. Hope this helps.

sp,

[Peter Godron]

Hi,

Please see:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1040464

Please also read:
http://forums1.itrc.hp.com/service/forums/helptips.do?#33 on how to reward any useful answers given to your questions.

[A. Clay Stephenson]

These tunables are obsolete at 11.23.

[Patrick Wallek]

You cannot add parameters to the kernel.

The 2 you mentioned are no longer used in 11.23, as Clay said.

If you have documentation that is mentioning those for 11.23, then it is incorrect.

[navin]

Patrick,
An oracle installation did not go through because of the parameters that i mentioned was missing.
So any idea about this.

[Patrick Wallek]

You would need to take this up with Oracle.

These parameters are not applicable to 11.23.

What version of Oracle are you installing? Is it supported with HP-UX 11.23/11iV2?