HPE Community
Operating System - HP-UX
1833042 Members
2469 Online
110049 Solutions
New Discussion

lan0 problem

 
R.A.Raju
New Member

‎05-23-2007 08:10 PM

‎05-23-2007 08:10 PM

lan0 problem

Hi,

In my server interface is lan0. when ever reboot the server manually i need to plumb the interface.

while booting the server
Configure HP SPP 100BT interfaces .... N/A
Configure LAN interfaces ........... FAIL

Physically i have 2 lan cards but lanscan cmd shows only one ethernet card.
0 Kudos
Reply
2 REPLIES 2
Luk Vandenbussche
Honored Contributor

‎05-23-2007 08:12 PM

‎05-23-2007 08:12 PM

Re: lan0 problem

What do you see in /etc/rc.log concerning this error.
0 Kudos
Reply
Steven E. Protter
Exalted Contributor

‎05-23-2007 08:13 PM

‎05-23-2007 08:13 PM

Re: lan0 problem

Shalom,

One of the cards is probably down.

ioscan, lets see if there is a NO_HW warning.

If ioscan shows two, lets run cstm/mstm or xstm and test the hardware.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.