Linkloop errors

[Steve Massey_1]

Hi

When using following command

linkloop -i1 -n2 -v 0x08000987F307

the response is
get_mesg2 getmesg faile, errno=4

Any ideas??

It's the correct NM No
Card and system are working fine


Thanks

Steve

[melvyn burnard]

What are you trying to linkloop to?

The following could be a possible anser to the symptom you are experiencing:

1) device you are trying to connect to is not on same subnet
2) switch or another network device blocks linkloop packets at hw level
3)device you are trying to connect to is bad

Just a few suggestions.