HPE Community
Operating System - HP-UX
1826420 Members
3070 Online
109692 Solutions
New Discussion

make_recovery

 
SOLVED
Go to solution
Tom Danzig
Honored Contributor

‎08-16-2000 08:04 AM

‎08-16-2000 08:04 AM

make_recovery

Anyone know for sure whether make_recovery is supported on V class servers? I've heard from various sources that it is not.

I'd hate to find out the hard way if it doesn't work!

Thanks,
Tom
0 Kudos
Reply
2 REPLIES 2
Kofi ARTHIABAH
Honored Contributor

‎08-16-2000 08:10 AM

‎08-16-2000 08:10 AM

Solution

Re: make_recovery

Yes ignite-ux runs on the v-class the limitation is that... "Firmware version 4.3 or higher is required to enable tape boot support for the V-Class. Contact
your local HP Representative for information about latest firmware
upgrades. " excerpt from
http://www.software.hp.com/products/IUX/docs/release_note_B.2.5.html

good luck
nothing wrong with me that a few lines of code cannot fix!
Reply
Tom Danzig
Honored Contributor

‎08-16-2000 08:14 AM

‎08-16-2000 08:14 AM

Re: make_recovery

Thanks Kofi. I'll check out firmware revision.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.