move hp735 installation to c180

[Whit Murrill]

I have a hp735 running 10.20 hp-ux with several applications e.g. ChemServer, Target, ... I want to move this installation to a c180 without reinstalling. I did a copyutil of the hp735's internal disks (7.6.0 and 7.5.0). After I restored them to the c180 and booted, the system paniced with error 'ccio driver not found in kernel'. How can I move this installation to the c180?

[Bruno Vidal · Accepted solution]

Hi,
The C180 system need some more driver than hp735, the easy way is to add all necessary driver on your 735 system (it will only build a kernel bigger, but still usable on the 735)
by using SAM. then doing your copyutil. I think you will need at least ccio, and pci drivers.

Cheers.

[Whit Murrill]

I was worried that the problem might be that the copyutil was copying hardware paths from the hp735 (7.6.0 and 7.5.0) that were invalid for the c180.

[Patrick Wallek]

You could try using Ignite/UX ( http://software.hp.com/products/IUX ) and making a make_tape_recovery tape on the 735, and then installing it on the C180. I would suspect you would run into kernel driver issues here too though.