HPE Community
Operating System - HP-UX
1833606 Members
3182 Online
110062 Solutions
New Discussion

Re: Network Interface Card Configuration error on BIND

 
Bernard Bravo
Advisor

‎04-16-2001 03:52 AM

‎04-16-2001 03:52 AM

Network Interface Card Configuration error on BIND

I'm having problem configuring my network interface card using SAM and a message like "Changes on /etc/hosts cannot be made ...BIND Database should be configured"

Question: How do I configure the BIND Database on HP-UX 11.0

I need the procedure for me to be able to connect to the network.

thanks... Hope some expert could Help Me.
Do good, Look Good, Feel Good
0 Kudos
Reply
2 REPLIES 2
Vincenzo Restuccia
Honored Contributor

‎04-16-2001 08:47 AM

‎04-16-2001 08:47 AM

Re: Network Interface Card Configuration error on BIND

You can configure your network with:
#set_parms
or edit /etc/rc.config.d/netconf and /etc/netconf after refresh network daemon with:
#/sbin/init.d/net stop
#/sbin/init.d/net start.
0 Kudos
Reply
Vincenzo Restuccia
Honored Contributor

‎04-16-2001 08:48 AM

‎04-16-2001 08:48 AM

Re: Network Interface Card Configuration error on BIND

You can configure your network with:
#set_parms
or edit /etc/rc.config.d/netconf and /etc/hosts after refresh network daemon with:
#/sbin/init.d/net stop
#/sbin/init.d/net start.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.