HPE Community
Operating System - HP-UX
1847253 Members
4459 Online
110263 Solutions
New Discussion

Re: Network "refresh" command?

 
JHL_1
Frequent Advisor

‎06-14-2002 06:35 AM

‎06-14-2002 06:35 AM

Network "refresh" command?

I'm in the process of changing/re-arranging my network connections. The addresses will remain the same as will the names. However when I run netstat now, the order in which the lan values appears is different (lan0, lan1, lan3...). Is there a command that "refreshes" the network and re-orders the lan connections in numerical order (again, lan0, lan1,lan2...)?
0 Kudos
Reply
2 REPLIES 2
Sanjay_6
Honored Contributor

‎06-14-2002 06:42 AM

‎06-14-2002 06:42 AM

Re: Network "refresh" command?

Hi,

I don't think there is any such command, except sort. But this is like sorting the output.

Hope this helps.

regds
0 Kudos
Reply
John Bolene
Honored Contributor

‎06-14-2002 07:04 AM

‎06-14-2002 07:04 AM

Re: Network "refresh" command?

Even after a reboot, my lan connections are not in order.

It may have been a happenstance that it was in order for you.
It is always a good day when you are launching rockets! http://tripolioklahoma.org, Mostly Missiles http://mostlymissiles.com
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.