HPE Community
Operating System - HP-UX
1825719 Members
2842 Online
109686 Solutions
New Discussion

Networks

 
Indrajit Bhagat
Regular Advisor

‎01-09-2007 05:27 PM

‎01-09-2007 05:27 PM

Networks

Hi Sir,
How to configure the First Lan Interface.
0 Kudos
Reply
2 REPLIES 2
Asif Sharif
Honored Contributor

‎01-09-2007 06:03 PM

‎01-09-2007 06:03 PM

Re: Networks

To configure interface lan0 with IP address 192.168.3.1, use the following command.

#ifconfig lan0 192.168.3.1 netmask 255.255.255.0 broadcast
192.168.3.255 up

or you can do it via SAM.

SAM -> Networking and Communications -> Network Interface Cards -> Select Interface and then assign IP.

Regards,
Asif Sharif
Regards,
Asif Sharif
0 Kudos
Reply
Luk Vandenbussche
Honored Contributor

‎01-09-2007 06:17 PM

‎01-09-2007 06:17 PM

Re: Networks

Use the commands

set_parms ip_address
set_parms addl_netwrk
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.