HPE Community
Operating System - HP-UX
1833785 Members
2318 Online
110063 Solutions
New Discussion

NIS Slave will not connect

 
SOLVED
Go to solution
MarkSyder
Honored Contributor

‎07-05-2005 10:04 PM

‎07-05-2005 10:04 PM

NIS Slave will not connect

Hi everybody.

A NIS slave has died so I am setting up an alternative on the same subnet.

Everything seems to go smoothly till I type ypwhich, which gives me the following error message:

ypwhich: clntudp_create error: RPC_PROG_NOT_REGISTERED

Any help appreciated and rewarded with points.

Mark Syder (like the drink but spelt different)
The triumph of evil requires only that good men do nothing
0 Kudos
Reply
2 REPLIES 2
Sudeesh
Respected Contributor

‎07-05-2005 10:26 PM

‎07-05-2005 10:26 PM

Solution

Re: NIS Slave will not connect

This error will come on a client machine if ypbind is not running. I am not sure in about this case (NIS slave).


Sudeesh
The most predictable thing in life is its unpredictability
Reply
MarkSyder
Honored Contributor

‎07-05-2005 10:42 PM

‎07-05-2005 10:42 PM

Re: NIS Slave will not connect

Well that was simple!

The one good thing to come out of this is that my knowledge of NIS has more than doubled in the last two days.

Mark
The triumph of evil requires only that good men do nothing
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.